Table of Contents
Advertisement
09 – SENDING MINUS
Setting value
01^ ONLY POSITIVE
02
POSITIVE & NEGATIVE
10 – SENDING FRAME RESULT
Setting value
01^ ONLY STABLE
02
STABLE & UNSTABLE
11 – STABILITY WAITING TIME
It specifies the waiting time for stabilizing the result. Time runs from the moment of requesting the
result by key pressing or serial interface request. The range of possible value settings is from 0 to
12 seconds. If the time was set at 0 seconds the result must be stable at the moment of requesting
the result. The default value of this parameter is 4 seconds.
12 – RECEIVING DATA LOCK
Setting value
01^ LOCK OFF
02
LOCK ON
13 – TRANSMISSION KEY LOCK
Setting value
01^ LOCK OFF
02
LOCK ON
14 – MESSAGE BEEP
Setting value
01
BEEP OFF
02^ BEEP ON
15 – FIXED TARE
Setting value
01^ AUTOMATIC TURN OFF
18
User Manual CAT 27 scales series
The negative result is considered as unstable and is
not sent.
The negative result can be sent if it is stable.
The result frame is sent only when the result is stable.
The result frame is sent after stabilizing the result or after the
time which is set in "
STABILITY WAITING TIME.
result hasn't stabilized during that time the frame that is sent
contains the signs 0x20 in place of the result digits.
The scale receives the commands via the
Receiving the data via the
The automatic configuration with the ELZAB cash
NOTE:
registers is also inactive.
Data can be transmitted by using the
Transmission of the data by using the
The acoustic error signaling switched off.
The acoustic error signaling switched on.
Single pressing of the
doesn't switch on the fixed tare. The fixed tare is switched on
only after pressing the key twice. If the "fixed tare" function is
switched off the tare will be automatically turned off after
weighing the articles and removing them from the platter.
Meaning
Meaning
Meaning
Connector.
PC
Connector is locked.
PC
Meaning
key.
key is locked.
Meaning
Meaning
key switches on the tare but
" If the
ELZAB S.A.
Advertisement
Table of Contents
