Table of Contents
Advertisement
05 – PARITY CHECKING
Setting value
01^ NO CHECKING
02
CHECKING ENABLED
06 – STABILITY CONDITION
Setting value
01
HIGHEST STABILITY
02^ HIGH STABILITY
03
LOW STABILITY
04
LOWEST STABILITY
07 – MINIMUM RESULT
Setting value
01
00 x e
02^ 01 x e
03
02 x e
04
04 x e
05
05 x e
06
10 x e
07
20 x e
08
50 x e
08 – TRANSMISSION MODE
Setting value
01^ AFTER PRESSING KEY
02
AUTOMATIC STABLE
03
AUTOMATIC CONTINUOUS
ELZAB S.A.
The parity checking means that bytes with the wrong parity
bit are discarded and the scale signalizes it by a beep.
This parameter determines the criterion of the result stability.
If the criterion is not met the result of weighing is considered
as unstable. The smaller the number of this setting the
stringent the stability criterion. A stable result is an obligatory
condition for activation of main scale functions: zeroing,
taring, weighing and sending the measurement result. If after
loading the scale doesn't send the result or send it with a few
seconds delay, the stability criterion should be broadened,
that is the number of setting should be increased.
Specifies the minimum result sent by the scale and the
minimum automatically disabled tare value.
The result is sent by the scale only at the request of the
operator e.g. after pressing the key or by the request
through the interface.
The result is automatically sent by the scale, just once, after
loading and stabilizing the indication. Before putting the article
on the platter the display should show
The result is sent only when the MINIMUM RESULT setting is
deferent from "00 x e".
Example: the "MINIMUM RESULT" value was set at = 20 x e = 040 g
the load put on scale was 036 g -> the scale doesn't send the result,
the load was increased to 042 g -> the scale sends the result.
The scale sends the results continuously at 0.12 sec. time
intervals. The unstable results are not sent but the result
frame (containing the signs 0x20 in place of the digits) can
be sent if the "
SENDING FRAME
was set.
UNSTABLE"
Meaning
Meaning
Meaning
Meaning
" for "
STABLE AND
User Manual CAT 27 scales series
and
.
17
Advertisement
Table of Contents
