Valve Mechanical Override Access Requirements; Oem Connections To Sam; Figure 54. Mechanical Valve Override Shaft(S); Figure 55. Sam Connections Labels (And/Or Tags) - Idex HALE SAM Operation Installation Maintenance Manual

5.5 Valve Mechanical Override Access Requirements

Position/orient all valves to provide access to the mechanical override shaft (Figure 54). The
shaft accepts a 7/16-in (11 mm) socket (or wrench). As much as possible position all valves to
provide valve override using the socket (with or without an extension) and a driver.
Figure 54. Mechanical Valve Override Shaft(s)

5.6 OEM Connections To SAM

Hale labels (and/or tags) SAM connection points (for OEM/apparatus builders) to aide in proper
installation. The SAM installation on an apparatus should be verified prior to delivery of the appa-
ratus per section (see paragraph 6.1, Commissioning, page 54) as a minimum. See Figure 55 for
an example of the Hale labels (and/or tags) identifying OEM/apparatus builder connection points
for a SAM system.
Typical labeled/tagged OEM/apparatus builder connection points are provided on 101-00341-
000. The drawing is located on the flash drive provided with the pump or available from the Hale
Products website.
Figure 55. SAM Connections Labels (And/Or Tags)
48