Reverse Function; Circuit Breaker Instructions - Weston BUTCHER Series Instructions Manual

9. Do not fill the last 3"–4" (7.5–10 cm) of casing. After the entire length of casing
has been stuffed, twist the open end to close and then tie off the ends of the
casing tightly to close. Twist into links.
10. Whenever stuffing sausage, fill the casing slowly to avoid air pockets. If air
pockets do appear in the sausage use a pin to prick the bubbles. The small
holes will seal naturally.

REVERSE FUNCTION

•
Allow the Grinder Motor to come to a COMPLETE STOP before engaging into
reverse "REV".
•
Allow the Grinder Motor to come to a COMPLETE STOP before engaging in forward
"FWD" after using the reverse function.
•
NEVER operate the Grinder in reverse for more than 5 seconds at a time.

CIRCUIT BREAKER INSTRUCTIONS

This Grinder is equipped with a Circuit Breaker as a safety precaution. If the Grinder stops
running, follow these steps to remedy:
1. Turn the Grinder to the "Off" (O) position.
2. Check the Grinder to see if there is a jam in the Grinder Head. If there is, the jam needs
to be cleared of the obstruction as outlined in "Grinding Tips."
3. Press the Circuit Breaker Reset Button.
4. Turn the Grinder back on and resume grinding.
5. If the Grinder still does not turn on, check that the electrical wall outlet is properly working.
Plug in another appliance to see if that appliance works from the wall outlet. Check that
the household circuit breaker has not been tripped. If none of the above steps remedy
the situation, or if the Circuit Breaker repeatedly shuts off the Grinder, contact customer
service for further assistance.
NOTICE: DO NOT continue to use the Grinder if the Circuit Breaker trips repeatedly.
Continued use may cause permanent damage to the Grinder and will void the warranty.
12