Balanced Body Allegro 1A Installing

Installing the Balanced Body
Allegro 1A with Riser Konnector
The Konnector is compatible with Balanced Body Reformers with
removable shoulder rests ONLY. If you aren't sure whether this
system will work with your equipment, please contact Balanced
Body at 1-800-PILATES (US and Canada), or +1-916-388-2838
(all other countries).
To view the installation podcast, please visit
www.pilates.com/instructions
TOOLS REQUIRED (NOT INCLUDED):
» Flathead screw driver
PARTS LIST (INCLUDED):
ITEM
Konnector Rope
Tri-Loops (Grey)
Tri-Loops (Black) with pulleys
Allegro 1 A Riser Post Assembly
Lower Mount Allegro Assembly
Under Carriage Mount Assembly
Low Support Bracket A1A
Flanged Shoulder Post, Black
Truss Head Screw 1/4-20 x 1-1/4"
Flat head cap screw 1/4-20 x 1-3/4"
Button head screw 1/4-20 x 3/4"
Plastic Washer A1A Konnector
Washer, Flat, 1/4"
1/4-20 Hex Nut
5/32" Allen wrench
7/16" Wrench
Spacer, Black, 1.5" Diameter**
**If your machine has legs disregard these spacers. If you
machine has rubber feet, unscrew each foot. Install the spacer on
top of the threaded rubber foot. Screw the foot/spacer assembly
back on machine so spacer is between the machine and rubber
foot.
1 2
WARNING: Using the existing shoulder posts with a Konnector
system can cause the loops to fall off the posts during use
which may cause injury.
REMOVE ROPES, POST AND SHOULDER BRACKETS
1. Remove the ropes from the cam cleats, carriage and pulleys.
They are no longer needed.
2. Remove the detent pin from the shoulder rest bracket.
Remove the shoulder rest bracket from the carriage. Repeat
on the other side.
3. Remove the screw and spacer furthest away from the
shoulder pad on the underside of each bracket. See Figure A.
PART NO. QTY
210-073 1
210-061 2
210-060 2
624-007 2
624-006 2
624-004 2
624-010 1
624-008 2
Figure A
GEN9235 2
4. Reusing the same spacer that was on the removed screw,
210-216 4
install spacer onto the truss head screws 1-1/4" long. Using
GEN7325 2
a flat head screw driver secure the truss head screw to the
607-545 2
bottom of each shoulder rest bracket. From the top side of
each bracket, thread by hand, the flanged shoulder post.
GEN9305 6
See Figure B.
GEN9056 2
GEN9282 1
5. Using the provided 5/32" Allen wrench and 7/16" wrench,
616-113 1
remove the four flat head screws as shown in Figure C. Keep
ALL0516 4
the nuts, they will be reused.
3 4
®
™
WARNING: If you are only using some of the loops, the
unused loops MUST be stored on the flanged shoulder
posts.
Figure B
Contact Us
1-800-PILATES | +1-916-388-2838
pilates.com | info@pilates.com
400-450 | 10.29.18