Videotec TWM1 Operating Instructions Manual page 21

TWP passive transmitter setup:
It is possible to attenuate the output video signal (on the terminal for twisted cable) setting the dip switches
according the values on the table. This function can be required in case of short distances, with receiver input
signal levels too high and with risk of saturation.
Dip position:
Note: in case of using the TWP as passive receiver, set all dip switches to "ON" position.
Dip1 Dip2
ON ON
OFF ON
OFF OFF
OFF OFF
Dip3 V terminal output
ON Vout (twisted)= V in (coax) x 1.15
ON
Vout (twisted)= V in (coax) x 1.15 / 2
ON Vout (twisted)= V in (coax) x 1.15 / 3
OFF Vout (twisted)= V in (coax) x 1.15 / 4
Pag. 5 MNVCTW_0610