hergom E-20 N Installation, Use And Maintenance Instructions page 25

E-20 N and E-21 N
The E-20 /21 wood stove has the following main characteristics:
 Made out of cast iron with pieces assembled, sealed and screwed to each other.
 Designed for use only with wood.
 Hearth which allows wood with a length of up to 45 cm to be burnt.
 Primary air regulation valve.
 Indirect primary air feeding system, which descends via the internal glass plane (self
cleaning) towards the back of the heath. Also fitted with a primary air orifice located in a
nozzle below the door gap to facilitate lighting.
 Secondary air with self-regulation, increasing performance of the stove and reducing the
unburnt emissions to the atmosphere.
 Self cleaning glass.
 Front opening door with glass
 Sealed ash pan door
 Optional flue, horizontal through the top section or vertical through the rear section. Ø 150
mm.
 Emits heat by radiation, directly heating walls, ceilings, etc.
 Supplied fully assembled from the factory, ready to be connected to the chimney.
The difference between these two heaters is the formal aspect of the door.
INTRODUCTION
Fig.1
25