Note: Between two vehicles, the device stores the ANYWHERE module ground slope. It is displayed in red with the "ATTENTION:
the slope is not updated" message.
If you wish to reuse the same slope without having to repeat a measurement using the ANYWHERE
module, confirm by pressing
Step 3: Choice of the headlamp height.
You must select the headlight height.
Position the CAP2600 WORKSHOP™ in front of the headlight inserts. (See section II).
Headlight
information to be
measured
The displayed height is expressed in metres. It is obtained by measuring the distance between the ground
and the lower edge of the headlight reflector.
Edit: 30/07/19 | Rev A | Page: 20
.