Capelec WORKSHOP CAP2600 User Manual page 20

Note: You can also manually enter a registration plate directly on the CAP2600 WORKSHOP™ by clicking
.
Step 2: Vehicle slope measurement using the ANYWHERE module
Position the ANYWHERE modules as close as possible to the vehicle wheels on the left side as shown
below. Module A (laser) on the front wheel and module B (target) on the rear wheel.
To activate the module A laser, press the switch for 2 seconds. Point it to the module B target line.
Press the switch again to validate. The laser flashes 3 times and sends the measurement. Then it turns off
automatically.
Edit: 30/07/19 | Rev A | Page: 18