Msr Configuration - Carriage Return - PIONEERPOS Asterix Touch-X5 Installation And Configuration Manual

MSR Configuration - Carriage Return

After entering the Configuration Mode (see: Enable Configuration Mode):
Note: Only use the numbers on your keyboard above the characters (see: MSR Configuration).
**** configuration mode ****
1:set interface
2:set magnetic string
3:set string editing
4:set buzzer
5:reset to default
6:show status
ration
0:exit setup mode
1:set enable tracks
2:set require tracks
3:carriage return
4:transmit ss/es
5:caps lock
6:track output order
7:change carriage return code
8:output cr if read nothing
9:raw data output
0:back
**** carriage return ****
1:don't send carriage return
2:after all tracks
3:after each track
4:after all data
0:back
1:set enable tracks
2:set require tracks
3:carriage return
4:transmit ss/es
5:caps lock
6:track output order
7:change carriage return code
8:output cr if read nothing
9:raw data output
0:back
**** configuration mode ****
1:set interface
2:set magnetic string
3:set string editing
4:set buzzer
5:reset to default
6:show status
7:set keyboard configuration
0:exit setup mode
1. Select 2 on your keyboard to choose set magnetic string.
2. Select 3 on your keyboard to choose carriage return.
3. Select 3 on your keyboard to choose after each track.
4. Select 0 on your keyboard to choose back.
5. Select 0 on your keyboard to choose exit setup mode you
should hear a long BEEP.
6. Exit Notepad.
Note: You MUST exit the configuration mode and Notepad
before performing any tests.
11 | P a g e