Mandik CP-M-B Manual page 8

KJM MANDÍK Controlling with CPM Wall-Mounted Control
.
Desired
The desired temperature correction value can be changed using the rotary knob
temperature
on the control - position D. The rotary knob corrects the desired temperature
correction
from the nominal temperature. The nominal temperature is set for each
Comfort or Attenuation mode in menu Components
Control. The minimum and maximum correction is set in menu Input/Output
Assignment
standard setting for Min and Max is 5 °C.
The status of the air-conditioning unit is indicated by the Run (position A) and
Unit status
Fault (position B) LEDs.
Run LED
Status
Flashing with
a period of 1
Flashing with
a period of 3
Fault LED
Flashing
Note The LED functions described above are standard ones and can be customized
according to client requirements.
NONO_CP-M-B_2019-6

External Switches
Meaning
OFF The unit is switched off.
The unit is in the Start auxiliary mode, which is preparing the unit to
start the fans.
sec.
ON The unit is started by the fan speed control knob position and the
Start auxiliary mode has ended.
The unit has started automatically based on the assessed need for
frost protection or room ventilation and the Start auxiliary mode has
sec. ended. When the conditions that caused the unit to start up are met,
the unit switches itself off. This status only occurs if the speed control
knob is in the OFF position and the Climatix controller is preset to the
Tempering mode.
Status Meaning
OFF No fault has occurred.
Indicates that a new fault has occurred.
ON Indicates a fault that persists after acknowledgment by the
operator.

Desired Temperature Min Max. The
www.mandik.cz

Temperature
8