Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Mandik CP-M-B
Summary of Contents for Mandik CP-M-B
-
Page 2: Table Of Contents
Table of Contents Introduction ..................3 Technical Data ..................4 Dimensions ................... 4 Electrical Wiring ................... 5 Installation .................... 6 Configuration of Climatix Controller ..........6 Operation of Wall-Mounted Control ........... 7 Maintenance ..................9 Waste Disposal ..................9 NONO_CP-M-B_2019-6 www.mandik.cz... -
Page 3: Introduction
KJM MANDÍK Controlling with CPM Wall-Mounted Control Introduction CP-M-B is a wall-mounted controller for Mandík air-conditioning units with the following parameters: Remote control of a Mandík air-conditioning unit For use with controllers Climatix POL6xx and POL4xx 1 rotary knob for setting the desired room temperature ... -
Page 4: Technical Data
Input load capacity min 100 kΩ Conductor cross-section 0.6 to 0.8 Recommended cable J-Y(ST)Y 4x2x0.8 Operating humidity 0 - 90 % Operating temperature 0 to +50 °C Storage temperature -20 to +60 °C Protection IP20 Dimensions 120x80x40 Dimensions NONO_CP-M-B_2019-6 www.mandik.cz... -
Page 5: Electrical Wiring
Power supply +24 V ss. supply Power Common ground supply The CP-M-B series wall-mounted control can only be powered from a DC power Note supply. The power supply must meet the requirements given in chapter ‘2 Technical data’. Terminal side NONO_CP-M-B_2019-6 www.mandik.cz... -
Page 6: Installation
KJM MANDÍK Controlling with CPM Wall-Mounted Control Installation The CP-M-B series wall-mounted control is designed for installation in indoor, Installation dry environments. It should be placed about 1.5 m above the floor at a place with good natural air circulation. The unit is suitable for mounting on most commercially available wiring boxes or directly on a wall. -
Page 7: Operation Of Wall-Mounted Control
Components Fans Inlet Comfort and Components Fans Outlet Comfort. MIN-MAX The fan speed changes continuously according to the rotary knob position from MIN to MAX. NONO_CP-M-B_2019-6 www.mandik.cz... - Page 8 No fault has occurred. Flashing Indicates that a new fault has occurred. Indicates a fault that persists after acknowledgment by the operator. Note The LED functions described above are standard ones and can be customized according to client requirements. NONO_CP-M-B_2019-6 www.mandik.cz...
-
Page 9: Maintenance
Disposal of The disposal of the unit is governed by regulations on the management of electronics electrical waste. The device must not be disposed of with normal household waste. It must be handed over at designated facilities and recycled. NONO_CP-M-B_2019-6 www.mandik.cz... - Page 10 MANDÍK, a.s. Dobříšská 550 26724 Hostomice Czech Republic Tel.: +420 311 706 706 E-Mail: mandik@mandik.cz www.mandik.com The producer reserves the right for innovations of the product. For actual product information see www.mandik.com...