Operation - Westfalia 97 07 49 Instruction Manual

Before using for the first time

Familiarize yourself with the units before using for the first time. Observe the
safety instructions and only use the units in compliance with these operating
instructions.

Remove all packaging components from the units.

Clean the units, as described in chapter „Cleaning".
Inserting batteries and filling
1. Hold the container (5) with one hand and turn the housing cover (8) counter
clockwise with the other hand. Pull the cover upright to remove it from the
container.
2. Pull the drive unit (3) and the transparent battery cover upright.
3. Insert 4 fresh batteries of the type LR6 (AA) into the battery compartment (2).
Observe the right polarity. The battery polarity symbols are shown in the
battery compartment. Use only alkaline batteries.
4. Fill the container up to approx. 80 % with pepper or salt through the filling hole
(4).
5. First, place the transparent battery cover
on the drive unit and then place the drive
unit with the included batteries in the
container. Make sure the connecting
wires are directed above the screws on
the container. Press the drive unit firmly
on the container.
6. Put the housing cover over the drive
unit. Turn the housing cover clockwise and tighten the container.

Operation


Press and hold the ON/OFF switch (1) in order to activate the grinding unit
and to switch on the built-in LED (6).

You can set the required grinding size by turning the screw (7):
clockwise
counter clockwise
Operation
= finer;
= coarser.
7