Majestic MERCURY Series Installation Manual page 55

1 1
TAB FOR LOG 3 TAB FOR LOG 3
Figure 5.
Log #2 (SRV2401-702):
Place the hole onto the shoulder screw as shown in Figure 5. Push the left side of Log 2 back until it contacts the back of
the basepan.
Log #3 (SRV2401-703): Locate the groove on the left side of Log 3. Place the log on the tab that was bent up in Step1
and set the right side of the log on top of the flat area on Log 2. Refer to Figure 5 for tab and flat area. Figure 6 shows Log
3 placed correctly.
1 1
4 4
3 3
Figure 7.
Log #4 (SRV2218-706): Place the log into the flat spots on Log 1 and Log 3. See Figure 9 and note that the barked side
is on the right. Position the back end so that it touches the back of the appliance.
Log #5 (SRV2397-705): Locate the center flat area on Log 1. Place Log 5 onto the center flat area with the bark facing
the back of the appliance. Rest the front of Log 5 onto the center flat area of Log 2. The back of Log 5 will touch the back
of the appliance.
Log #6 (SRV2397-705): Locate the flat areas on Log 1
and Log 2, highlighted in Figure 6. Place log 6 onto the flat
area of Log 2 with the bark facing the front of the appliance.
Rest the back of Log 6 onto the flat spot on the far right of
Log 1. Log 6 will rest against the back of the appliance.
2 2
FLAT AREA FOR LOG 3 FLAT AREA FOR LOG 3
Locate the hole on the bottom side of Log 2 and the shoulder screw marked "2" in Figure 3.
2 2
Majestic • MERC32IN, MERC32IL Installation Manual • 2401-980 Rev. L • 1/21
FLAT AREAS FOR LOG 5 FLAT AREAS FOR LOG 5
1 1
3 3
GROOVE GROOVE
Figure 6.
FLAT AREAS FOR LOG 6 FLAT AREAS FOR LOG 6
1 1
4 4
3 3
Figure 8.
4 4
1 1
3 3
Figure 9. LOGS-MERC32 Installed
FLAT AREAS FOR LOG 4 FLAT AREAS FOR LOG 4
2 2
5 5
2 2
BARK ON RIGHT SIDE BARK ON RIGHT SIDE
5 5 6 6
2 2
2401-910B
55