Table of Contents
Advertisement
Pentair Pool Products
Check the Load Center
1. Turn on the electrical power at the house
breaker.
2. Turn on the Load Center. You may need to turn
on the breakers on the Load Center.
3. Wait for the following:
· In the System Control lights area, only one
· The light labeled See Indoor Control
4. Press the Service button to put the Load Center
in Service Mode for testing.
Note: If you are working with the i5, i7+3, or
i9+3 systems, go to step 5. If you are working
with the i5S, i9+3S, or i10+3D systems, skip step
5 and go to step 6.
5. Press the Valves button. Step thru all 4 valve
positions: Pool, Spa, Fill, Drain. Make sure the
valves turn on correctly and the water is moving
in the correct direction for each position.
6. Press the Filter Pump button. Make sure the
filter pump turns on correctly. If the pump has 2
speeds: Press the button 1 time to run the pump
in low speed. Press the button again to run the
pump in high speed. Press the button again to
turn the pump off.
7. Step through the rest of the system control
buttons. Notice which button turns on which
equipment. You may need to walk the property
to find what each button turns on.
8. Write down what each button turns on,
including the number of the circuit.
9. Label the circuit buttons on the outdoor control
panel. You need this information when you set
up the Indoor Control Panel.
When you are done, you are ready to set up the
Indoor Control Panel. See the next section.
Rev. B 3-19-04
light is on, usually the Auto light.
Panel if Flashing stops flashing.
5
Quick Start Guide
P/N 520366
Advertisement
Table of Contents
