Table of Contents
Advertisement
Quick Start Guide
Setting up Additional Equipment
If any special equipment is attached, you need to set that up now. You may or may not have
this equipment.
This section explains setting up the following:
•
Solar or heat pump equipment - Lets you set solar or heat-pump heaters to work.
•
2 speed pump - Lets you set circuits that switch the filter pump to high speed.
•
Cool-down cycle for the heater - Lets you set a cool-down cycle for heaters that need it.
•
Automatic spa heating when the spa is manually turned on - Heats the spa using the
Spa button on the Indoor Control panel or the spa-side control, even when the heater is
set to OFF in the Heat screen. This lets the homeowner heat the spa on-demand. Timed
programs will not heat the spa.
To set up the solar equipment
Getting There
MENU SETUP EQUIPMENT SOLAR
Go to the Solar screen.
1. Press the button next to the Water
Solar Present label to change it to Yes.
2. If a heat pump is being used instead
of a solar heating system, press the
second button to change it to Yes.
3. When you are done, press the Save
button.
4. Press the Exit button to return to the
Main screen.
To set up a 2 speed pump
Getting There
MENU SETUP EQUIPMENT 2-SPEED PMP
Go to the 2 Speed Pump screen.
1. Press the button next to a None label.
You see a small arrow pointing to the
name of that label.
P/N 520366
10
Pentair Pool Products
Rev. B 3-19-04
Advertisement
Table of Contents
