Safety Instructions - HBM KMR Mounting Instructions

17
KMR

Safety instructions

Use in accordance with the regulations
The KMR are intended for the measurement of forces in test rigs / press-fit fa-
cilities / test systems / presses. Any other use is deemed to be not in accor-
dance with the regulations.
In the interests of safety the transducer should be used only as specified in
the mounting instructions. It is also essential to comply with the statutory and
safety regulations in force for the particular application. The same applies to
the use of accessories.
The transducer is not a safety device as defined for use in accordance with
the regulations. Perfectly safe operation of this transducer demands appro-
priate transport, as well as technically correct storage, installation and moun-
ting combined with careful operation and maintenance.
General dangers due to non-observance of the safety instructions
KMR comply with the state of the art and are fail-safe.
The transducers can give rise to residual dangers if they are inappropriately
installed and operated by untrained personnel.
Any person responsible for the installation, commissioning, maintenance or
repair of a force transducer must have read and understood the mounting in-
structions and in particular the technical safety instructions.
Residual dangers
The scope of performance and supply covers only part of measurement
technology. In addition, equipment planners, installers and operators should
plan, implement and be responsible for the technical safety aspects of force
measurement technology in such a way as to minimise the residual dangers.
Prevailing regulations must be complied with at all times. The residual
dangers connected with the force measurement technology must be referred
to explicitly.
A2114-1.0 de/en HBM