Iwatsu HV-P60A Instruction Manual page 18

High Voltage Probe HV-P60A
B. When Probe body is set up horizontally or downward and
used for the stand
* Refer to following 1) to 5) and Figure 4(a), (b) and (c).
1) The bottom of Probe body is fixed from the back of the
probe receiving part by removing the probe receiving part
from the stand, and using four screws of the attachment for
the stand (Refer to Figure 4(b) and Figure 4(c)).
2) The banana chip terminal (green) for the playground in the
stand is inserted in the terminal GND of the bottom of
Probe body.
3) The output cable is passed from the hole plug (Refer to last
page and Figure 4(a)) on the stand side, and it is drawn out
from the hole in the probe receiving part.
4) The output cable is connected with the bottom of Probe
body.
5) The probe receiving part is fixed to the stand with four
make-up screws. (Refer to Figure 4(b))
6) The position in which the stand is installed is chosen, and
the stand installation hole is fixed with the screw etc. (Refer
to four places and Figures 4(b))
Probe receiving part
Probe stand
SK-301
Figure 4(b) Probe stand SK-301 and Probe receiving part
Note
When buying it, probe stand SK-301 has installed the probe receiving
part for HV-P30A. Replace the probe receiving part for HV-P60A and
replace the top and bottom. (Refer to the manual of SK-301 for details.)
Make-up screw (four places)
8
Stand installation
Hole (four places)