Getting Started; Default Factory Settings - CTEK Z45 Series User Manual

Getting Started

Default Factory Settings

Factory default settings are defined in the table below. Factory settings can be restored
any time by pressing and holding the default switch for 5 seconds and releasing it when
the service and link LEDs begin a repetitive (red/orange) flashing routine. At that point
the device will reboot (power-cycle) and will return to service with the factory defaults
in place.
Setting or Parameter
Administrative User ID
Administrative password
Administrative IP address
Network Configuration
DHCP Server
Administrative LAN and WAN port
Firewall Status
WAN Ping Response
NAT Traffic to WAN
XML Interface
IP White List
SMS Management
SMS White List
SSH (Secure Shell) Access
SSH User ID
SSH Password
Enable HTTPS
Connection State (WAN)
Time Source
Location Source
DNS Address Source
Radio module firmware
Z45X SERIES INDUSTRIAL CONTROLLERS - DECEMBER 23, 2020
Factory Default
ctek *** Change after first login ***
ctek *** Change after first login ***
192.168.1.10
Gateway
Enabled
Port 80 – See security section below
Enabled – See security section below
Disabled – See security section below
Enabled – See security section below
Disabled – See security section below
Disabled – See security section below
Disabled – See security section below
Disabled – See security section below
Disabled – See security section below
root – See security section below
pass – See security section below
Disabled – See security section below
Enabled
Cellular Network
GPS (Internal)
Acquire from Wireless Network
Verizon - SWI9X15C_05.05.63.01 or newer
6