Subzero CRC 1200 User Manual page 2

Index
PARAMETER
Introduction
Get to Know Your Controller
Key Introduction
Main Programming Mode
Parameter List
SET POINT To set the cut-out point of the controller.
MAX SET POINT To set the Maximum System Cooling
temperature.
MIN SET POINT To set the Minimum Cooling
Temperature.
DIFFERENTIAL To set the differential for Compressor
restart.
QUICK FREEZE SP To set Quick Freeze Set Point.
QUICK FREEZE DUR To set Quick Freeze Duration.
ROOM PROBE CAL To set Room Probe 1 calibration.
COMP TIME DELAY To set time delay between compressors
relay restart time.
DRIP TIME DUR To set drip time for defrost water.
POST DRIP TIMING To set Post Drip Timings.
COMP ON PRB.FAIL To set compressor function during
Room probe failure.
CONDENSOR ON DLY To Set Condensor On Delay Timings.
EVAP FAN STOP TC To set Evaporator Fan Stop
Temperature.
EVAP TIME DELAY To set Evaporator Restart Time Delay.
EVAP Wn COMP OFF To set Evap Fan operation when
compressor is off.
01
Pg.
DESCRIPTION
No.
3
4
5
5
5
5
6
6
7
7
7
8
8
9
9
9
9
10
10
10
CRC1200
Index
PARAMETER
EVAP DIFFERENTIAL To set Evaporator Differential.
COIL PROBE CAL. To set coil probe calibration.
EVAP At DEFROST To set Evap. Fan status during defrost.
EVAP At DOOR Open To set Evap. Fan status during Door
open condition
DEFROST TYPE
To set type of defrost.
DEFROST COMPUTING To set type of computation for defrost
time.
DEFROSTFREQUENCY To Set Defrost frequency.
To set Maximum Defrost duration.
DEFROST DURATION
To set final defrost temperature.
DEFROST STOP
(Coil probe).
TEMPERATURE
POWER ON DEFROST To activate power ON Defrost.
DEFROST DURATION IN To set Defrost duration IN Coil probe
COIL PRB. FAIL Failure.
PUMP DOWN To activate Solenoid Valve Relay.
KEYPAD LOCK To activate Keypad Lock.
FACTORY RESET To revert to Factory Parameters.
SAVE PROGRAMMING To Save programming.
Technical Data
Technical Data
Wiring Diagram
Caution & Warranty
CRC1200
Pg.
DESCRIPTION
No.
10
11
11
11
11
12
12
12
13
13
13
14
14
14
14
15
16
17
18
02