Table of Contents
Advertisement
Connect the water supply hose and power and perform a test run.
4
• Listen carefully to the consumer's description of the fault and proceed with the following procedure as much as possible:
Get ready
세탁준비 과정
• Connect to a dedicated 220 V outlet.
220V 전용 콘센트에 연결
• Connect the water supply hose to a cold
냉수 수도꼭지에 급수호스
water tap.
연결
Check the wash water heating
세탁수 가열 확인
• In Test mode, press the Start button ten
Test mode에서 Start버튼
times and check whether the wash water
10회 누른 후 가열 확인
heats up.
Check drain and spin-dry
배수 및 탈수확인
• Select spin-dry mode, check drain, and
spin-dry.
탈수단독 코스를 선택하여 배수
및 탈수를 확인
Base the service sequence on the result of the fault diagnosis.
• Perform the service based on the result of the fault diagnosis according to 6. Fault Diagnosis and Solution
Matrix.
• If disassembly and assembly are required, follow 7. How to Disassemble and Assemble.
Once the service is completed, check the condition against 9. Post-repair Check.
Press the Power button
전원 버튼 누름
Check automatic turning
자동 반전 확인
• Check whether the tub turns left and
급수 시작 후 드럼의 좌우
right after water supply starts.
반전 확인.
Touch the Start/Pause button
동작/일시정지 터치
• Press the button and wait for the tub to
stop turning. Check for the solenoid
operating sound as the washer door
unlocks. (You will hear a "tick" once or
twice before power is turned off.)
15
Touch the Start/Pause button
동작/일시정지 터치
Check water supply
급수 확인
• Check water supply through the front
전면부 급수 확인
window.
Remove remaining water
잔수 제거
Pump cap
펌프 마개
Remaining water
잔수 제거용
removal
호스
hose
시운전 후 서비스 할 필요가
• If servicing is required after the test run,
open the bottom cover, remove the
있을 때 제품 하단의 Cover을
residual water hose cap, and drain the
열고, 잔수제거 호스마개를
remaining water.
빼내어 잔수를 제거하세요.
Hose cap
호스
마개
Advertisement
Table of Contents
