Table of Contents
Advertisement
Connecting water supply hose
• Water supply pressure must be between 100 kPa and 1000 kPa (1.0 ~ 10.0 kgf / cm
• Do not strip or crossthread when connecting inlet hose to the valve.
• If the water supply pressure is more than 1000 kPa, a decompression device should be installed.
• Periodically check the condition of the hose and replace the hose if necessary.
Step1 : Check the rubber seal of the inlet hose
Hose
connector
Rubber
seal
Step2 : Connect hose to water tap
Type-A : Connecting Screw-type hose to tap with thread
Type-B : Connecting Screw-type hose to tap without thread
Upper
connector
Fixing screw
Water supply
hose
• Two rubber seals are supplied with the water inlet hose.
They are used for preventing water leaks. Make sure the connection to
taps are sufficiently tight.
• Fasten the hose connector onto water supply tap.
1. Unfasten the adapter ring plate and the 4 adapter retaining screws.
Rubber
2. Push the adapter onto the end of the tap so that the rubber seal forms
packing
a watertight connection. Tighten the adapter ring plate and the 4
screws.
3. Push the water supply hose vertically upwards so that the rubber
packing in the hose connects fully to the tap and then
tighten it by fastening clockwise.
Plate
)
2
11
Advertisement
Table of Contents
