Advertisement
300X USER GUIDE
YOUR FIRST PRINT
13. Plug in the power in the back and flip the switch on
the right side to turn it on. It will take about a minute for
the internal Raspberry Pi computer to boot.
15. Follow the on screen instructions for the initial
setup, Wi-Fi, and calibration settings for your new 3D
printer.
Follow the instructions to download the latest printer
firmware and update to the newest features.
The name you give to your printer will be used to
connect to it over a web browser.
The on screen tutorials will walk you through how to
calibrate and 3D print on the 300x.
No downloaded software is required to slice files or
operate the 300x!
This work is licensed under the creative commons Attribution
Non commercial-no Derivatives 4.0 International license.
14. Choose Mode.
The 300x comes with two different modes:
Home/Office and Education.
One is for hobbyists and businesses, while the education
mode includes tutorials and extra on how to 3D print.
You can change your mode and other settings at any
time by tapping menu at the bottom of the screen.
16. To connect to the 300x wirelessly using a web
browser, either connect the printer to your Wi-Fi,
ethernet, or connect to the Wi-Fi network on your
computer named "Maker Made" that the printer
broadcasts until it connects to your network.
Then, open any web browser and go to:
http://[your-printer-name].local
Note: Bonjour Print Services must be installed for the
printer page to load on a Windows computer.
To install Bonjour, install any Apple program (such as
iTunes) on your computer or find the newest stand-alone
version at support.apple.com.
9
Last Updated 12.23.2020
Version v1.1
Advertisement
