Advertisement
300X USER GUIDE
3D PRINTER ASSEMBLY
7. Plug gantry into base, with connector clip on top.
9. Plug in X-axis stepper motor and smaller limit switch.
The wires are labeled with an "X".
11. Attach filament axel to mount by inserting axel
threads through the mounting hole. Hand thread to
tighten the nut on the opposite side of the slanted
L-bracket.
This work is licensed under the creative commons Attribution
Non commercial-no Derivatives 4.0 International license.
8. Plug in both Z-axis stepper motors from the back of
the printer. The connection will only fit one way.
10. Plug in extruder stepper motor, the wire labeled "E".
12. Use two long Phillips screws to attach filament
holder to the top left of the gantry. Face the axel toward
the back of the printer.
8
Last Updated 12.23.2020
Version v1.1
Advertisement
