Advertisement
300X USER GUIDE
5. Click the tab that reads "Extruder 1". In the box next to
"Compatible Material Diameter" replace the numbers with
"1.75" as shown. Then click "Next".
Drew's Note: The correct material diameter is very
important! If you don't change this command, your prints
will come out squishy and under-extruded. All of the
printer Gcode is based on algorithms around the correct
material diameter.
6. Your printer is almost set up! We just need to upload the proper profiles for
printing. Click the profile tab, where it says "Fine 0.1mm".
This work is licensed under the creative commons Attribution
Non commercial-no Derivatives 4.0 International license.
13
Last Updated 12.23.2020
Version v1.1
Advertisement
