Advertisement
300X USER GUIDE
3D PRINTER ASSEMBLY
1. Unbox 300x and remove all foam from the base.
3. Use a 3mm Allen wrench (largest) to screw 2 long
silver M4 bolts into each side of base to secure the
gantry.
5. Attach the screen mount to frame using 2.5mm Allen
wrench (middle sized) and two black M3 bolts.
This work is licensed under the creative commons Attribution
Non commercial-no Derivatives 4.0 International license.
2. Place X-axis gantry into ports on top of the base, with
the silver and black stepper motors toward the back and
the nozzle toward the front.
4. Plug in microUSB (into either port) and HDMI into
back of screen. It is a tight fit, so ensure that the HDMI
is plugged in completely. Plug the other end of the USB
into one of the Raspberry Pi USB ports.
6. Plug in print bed to base, with connector clip on top.
7
Last Updated 12.23.2020
Version v1.1
Advertisement
