Braun VISTA 2 NVL Series Service Manual page 16

Maintenance and Lubrication Schedule
continued
Inspect gas springs (cylinders - 6) for wear or dam-
age, proper operation and positive securement
Inspect saddle bearing (UHMW - 2)
Inspect vertical arm plastic covers
4500
Inspect power cable
Cycles
Mounting
Decals and Antiskid
Consecutive
Repeat all previously listed inspection, lubrica-
750 Cycle tion and maintenance procedures at 750 cycle
intervals.
Intervals
Page 14
Tighten, replace or correct as needed
Apply Door-Ease or replace if needed. See Lubri-
cation Diagram.
Resecure or replace if needed.
Resecure, repair or replace if needed.
Check to see that the lift is securely anchored to
the vehicle and there are no loose bolts, broken
welds, or stress fractures.
Replace decals if worn, missing or illegible. Re-
place antiskid if worn or missing.