Braun VISTA 2 NVL Series Service Manual page 14

Maintenance and Lubrication Schedule
continued
Lift-Tite ™ latch gas (dampening) spring pivot
points (2 springs - 4 points)
Platform side plate slots
Inspect Lift-Tite
springs for wear or damage (bent, deformed or
misaligned), positive securement (lock nuts /
external snap rings) and proper operation
750
Inspect outer barrier for proper operation
Cycles
Inspect outer barrier latch for proper operation,
positive securement, and detached or missing
spring(s)
Inspect lift for wear, damage or any abnormal
condition
Inspect lift for rattles
Perform all procedures listed in previous section also
Inner/outer fold arms (2)
Platform pivot pin bearings (4)
Outer fold arm bearings (8)
Inner roll stop pivot bearings (2)
Inner roll stop lever bearings (2)
Inner roll stop lever slot (2)
Saddle support bearings (8)
Inner fold arm roller pin bearings (4)
1500
Inner fold arm cam followers (4)
Cycles
Parallel arm pivot pin bearings (16)
Handrail pivot pin bearings (4)
Hydraulic cylinder pivot bushings (8)
Inspect Lift-Tite
positive securement and proper operation (2)
Inspect inner roll stop for:
• Wear or damage
• Proper operation. Roll stop should just rest on
top surface of the threshold plate.
• Positive securement (both ends)
Inspect handrail components for wear or damage,
and for proper operation
continued
Page 12
™ latches and gas (dampening)
™ latch rollers for wear or damage,
Apply Light Oil - See Lubrication Diagram
Apply Light Grease - See Lubrication Diagram
Resecure, replace damaged parts or otherwise
correct as needed. Note: Apply Light Grease to
Lift-Tite ™ latch tower pivot point if replacing latch.
Correct or replace damaged parts.
Correct or replace damaged parts and/or relubri-
cate. See Lubrication Diagram
Correct as needed.
Correct as needed.
Apply grease (synthetic) to contact areas between
inner/outer fold arms. See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Correct, replace damaged parts and/or relubricate.
See Lubrication Diagram.
Resecure, replace or correct as needed. See
Platform Angle Instructions and Tower Microswitch
Adjustment Instructions.
Replace damaged parts.