Jet AFS-1000B Operating Instructions Manual page 5

Fig 2
Hang the unit, using four eyebolts (B,
Fig 2) and four hex nuts (C, Fig.2)
provided.
Note:
Make sure that the chain and
ceiling hooks are properly rated
for hanging this unit.
Hang the unit with at least 2,1 m
clearance to the floor.
5.2.1 Installation of Iron net guard
Note:
Must install the iron net guard
provided with the machine For the
safety consideration.
Attach and fix the iron net upon the
"L" bar inside the machine case with
6 tapping screws and 6 flat washers
(Fig 2-1 , 2-2 and 2-3)
Fig 2-1
Fig 2-2
Fig 2-3
Note:
Must remove the Styrofoam block
inside the machine case before
install the net guard.
Check and read the attention tag
hang on the outer filter packing
5.3 Mains connection
Mains connection and any extension
cords used must comply with
applicable regulations.
The mains voltage must comply with
the information on the machine
licence plate.
The mains connection must have a
10 A surge-proof fuse.
Only use power cords marked
H05RN-F
Connections and repairs to the
electrical equipment may only be
carried out by qualified electricians.
6. Machine operation
6.1 Remote control operation
The TIME button (A, Fig 3) controls
the timer setting.
The air filtration system will operate
for either 2, 4 or 8 hours before it
shuts off.
Fig 3
The SPEED button (B, Fig 3)
controls the air volume flow. You can
choose between low, medium and
high.
There is also a manual SPEED
button (A, Fig 4) on the backside of
this unit which controls the speed.
The ON/OFF button (C, Fig 3) turns
the unit on and off.
There is also a manual ON/OFF
button (B, Fig 4) on the backside of
the unit.
Fig 4
6.2 Overload protection
The fuse switch (C, Fig 4) will pop
out in case of overload. Wait 5
minutes and push the fuse back in.
7. Maintenance and inspection
General notes:
Maintenance, cleaning and repair
work may only be carried out after
the machine is protected against
accidental starting by pulling the
mains plug.
Inspect the proper function of the air
filtration system daily.
Replace clogged filters.
Clean the unit regularly.
Defective safety devices must be
replaced immediately.
Repair and maintenance work on the
electrical system may only be carried
out by a qualified electrician.
7.1 Changing Filters
Disconnect the machine from the
power source.
During the changing or cleaning
of the filters it's necessary to use
a mask (mask with filtration).