Electrical Connection; Operating Options; On-Site Operation - Prosense ETS Series Operating Instructions Manual

4 Electrical Connection

A1
A1'
1
2
3 4
R1
ETSxxN-xx-1001
ETSxxN-xx-1003
A3
A3'
2 1
4
3
4...20mA
ETSxxN-xx-1001
A1: 2x PNP switch outputs R1 and
A1': 2x PNP switch outputs R1 and
A2: 1x PNP switch output and 1x analog output (4 to 20 mA)
A3: 1x analog output (4 to 20 mA) and 1x PNP switch output
A3': 1x analog output (4 to 20 mA) and 1x PNP switch output
(diagnosis / NC contact with "DESINA" setting)
1
To avoid the analog input damaging of a PLC, do not connect the active PNP switch
output of the device to the 4...20 mA input of a PLC.
For more information about DESINA, see www.desina.de
(See also Basic Settings section in this manual.)

5 Operating Options

5.1 On-Site Operation

The ProSense ETS Series is programmed and operated by means of three keys or by
using XT-SOFT programming software (see the Programming with XT-SOFT Software
section of these instructions). The digital display and the light emitting diodes (LEDs)
support navigation in the operating menu.
LED red/ green blinking = warning
User Manual - ETS Series Digital Temperature Sensors
A2
L+
2
3
1
L–
L+
L–
(R2)
1
(diagnosis/NC contact with "DESINA" setting)
1
Operating keys
LED for status
Green = ok
Red = error/fault
Communication jack
for personal computer
1
4
R1
ETSxxN-xx-1001
Cable Assembly Wiring Colors:
Pin 1 - Brown
Pin 2 - White
Pin 3 - Blue
Pin 4 - Black
Note: Wiring colors are based on AutomationDirect CD12L
and CD12M 4-pole cable assemblies.
Wiring diagram is based on user selected configuration.
(R2)
1
E
Digital display
Illuminati on white (= ok)
Illuminati on red (= error/fault)
Yellow LEDs for swit ching states
LED on = swit ch closed
LED off = swit ch open
ETS Digital Temperature Sensors Rev. 1
L+
4...20mA
L–
1
2
4
3
+12 to 30VDC
OUT2
OUT1
0VDC
5