Certificates And Approvals; Installation; Installation Conditions; Mounting The Device - Prosense ETS Series Operating Instructions Manual

User Manual - ETS Series Digital Temperature Sensors
• Hazardous Locations
The ProSense ETS Series is not approved for use in Hazardous Locations.

2.4 Certificates and Approvals

CE mark, declaration of conformity
The device is designed to meet state-of-the-art safety requirements and left the factory
in a condition in which it is safe to operate. The device complies with the standards EN
61010-1 "Protection Measures for Electrical Equipment for Measurement, Control,
Regulation and Laboratory Procedures" and with the EMC requirements of IEC/EN
61326. The device meets the legal requirements of the EU Directives. The manufacturer
confirms a positive completion of all tests by fitting the unit with a CE mark.
UL Approval
UL Listed

3 Installation

3.1 Installation Conditions

Do not thread sensor into process connection by turning the housing. Always use a
wrench on the wrench flats to tighten the sensor into the process connection.

3.2 Mounting the Device

Possible installation options for temperature monitoring in pipes:
1
1 Hexagonal screw on sensor module
General mounting instructions:
• Installation at angle pieces, against the direction of flow (item A).
• Installation in smaller pipes, inclined against the direction of flow (item B).
• Installation vertical to the direction of flow (item C).
• The on-site display can be rotated electronically 180°.
• The housing can be rotated up to 310°.
4
ETS Digital Temperature Sensors Rev. 1
120 °C
A
C
B