Table of Contents
Advertisement
6. INSTALLING ELECTRICAL CONNECTION
BE USED TO SECURE THE
IT IS RECOMMENDED THAT
CONNECTED TO THE MAINS
RATED AT 3 AMPS. ENSURE
1. Site the mains power supply box close to the inlet to the tap and solenoid valve. Use the length of
the sensor cables for guidance.
2. Remove glands and nut.
3. Secure the box to the wall. To avoid cables contacting water, mount the Mains Power supply box
Place gland nuts and glands on cables and pass cables through glands into the mains power
supply box.
5. Wire the mains connector observing polarity. Note that the mains supply connection terminal
Connect the Eye sensor cables to the power supply unit and solenoid valve as shown above.
7.
mains supply box.
SWITCH
MUST BE
MAINS
6
CONNECTION
RED
PRE-FITTED IN
Advertisement
Table of Contents
