Table of Contents
Advertisement
1. IMPORTANT
Read this manual before installation
2. INTRODUCTION
Performa Electronic Sensor Taps are available with two types of Sensing Technology:
1. Optical Sensor taps use infrared light to
detect a user's hands in the area beneath
the spout. When a detection is made in the
solenoid valve is operate for a pre-set period
to provide water at the outlet.
timer. Neither sensor taps require physical contact to operate.
3. PREPARATION
Take extra care to ensure the electrical connections are correct, securely connected and
where applicable the relevant seals and glands are used to protect the electronics.
basin.
Do not solder near the solenoid valve, excessive heat will damage the valve and its
connections.
pipework thoroughly before installing the solenoid valve.
WALL
DECK
1. Remove old tap
WALL
DECK
2. Drill hole
2
around the whole tap body that can detect a
the solenoid valve and water is provided at
the outlet.
WALL
DECK
3. Thoroughly clean mounting
area
Advertisement
Table of Contents
