Configuring Dialogic Pci Linecards In Dialogic Configuration Manager - Dialogic D/41EPCI Manual

Dialogic PCI Linecard Installation and Replacement
Configuring Dialogic PCI Linecards in Dialogic
Configuration Manager
The Dialogic Configuration Manager (DCM) is a utility that allows you to configure a
number of parameters used by the Dialogic System Software to control the Dialogic
linecards installed in the platform. Each time you start the DCM, it automatically detects
any such linecards and matches them with the corresponding configuration data. All of
the linecards detected by the DCM and matched to configuration data appear in the list of
Configured Devices on the main DCM window.
You can use the DCM to change the configuration data for any of the linecards in the
Configured Devices list. The configuration of the Dialogic System Software can only be
changed when the Dialogic system service is stopped. Conversely, the DCM will not
apply the changes you make to the settings of the Dialogic System Software until you
restart the Dialogic system service.
The DCM has a comprehensive online help system. Consult the Dialogic
Note
Installation and Configuration Knowledge Base book in the help system for
advice about troubleshooting the Dialogic System Software SR5.01.
To configure a Dialogic linecard:
Verify that the OneBox service is shut down and that the Automatic Startup box is
1.
unchecked in the System tab of the Configuration utility.
From the Start menu, point to Programs, point to Dialogic System Software, and
2.
select Dialogic Configuration Manager – DCM.
30
ã
R3B Aug 2001 Ericsson Enterprise AB