Connect The Cables; Cold Startup Delay Switch - Axis P1343-E Installation Manual

AXIS P13-E Network Camera Series Installation Guide

Connect the cables

1. Optionally insert an SD memory card (not included) into the SDHC (Secure Digital High
Capacity) card slot. A standard or high capacity SD card is required to store images locally in
the camera.
2. Optionally connect external input/output devices. See page 21 for information on the terminal
connector pins. Prepare the cables with gaskets, see Prepare the network cable, on page 8, and
route the cables through the cable holes into the bottom cover and to the camera.
3. Connect the camera to the network using a shielded network cable. Connect the network cable
to the network connector on the bottom. The network cable and the I/O cable between the
bottom cover and the camera are already connected at delivery
4. Check that the indicator LEDs indicate the correct conditions. See the table on page 23 for
further details. Note that the Status LED can be configured to be unlit during normal operation.

Cold Startup Delay Switch

The housing used in this Axis product features Arctic Temperature Control, which is enabled by
setting the Cold Startup Delay switch to I (ON). When enabled, this function controls when the
camera restarts after a power cut, when temperatures are below 0 °C (32 °F); the camera is first
heated to approximately 0 °C (32 °F) before it initializes. This prevents damage to camera models
that include moving parts. Since this camera does not require this function, it is disabled by default.
Network cables
I/O cable
Bottom cover
Network connector (PoE OUT,
connected at delivery)
Cable holes
Network connector (PoE IN)
LED indicator
Cold Startup Delay switch
(enabling not required - see text below)
Alarm output
(connected at delivery)
Page 11