Chapter 1 General Information; General Information; Warranty And Liability Claims; Regulations - Guidelines - Helios AIR1-BE TOUCH Installation And Operating Instructions Manual

Operating instructions
CHAPTER 1
GENERAL
INFORMATION
m
Controller - AIR1-BE TOUCH
1 .0

General information

To ensure safety and correct operation please, read and observe the following
instructions carefully before proceeding. All relevant national standards, safety
regulations and provisions (e.g. DIN EN VDE 0100) and the technical connection
conditions of the electrical supply company must be observed and applied.
Keep the installation and operating instructions as a reference at the device.
After the final assembly, the document must be handed to the operator (tenant/
owner).
1 .1 Warning and safety instructions
The adjacent symbol is a safety-relevant prominent warning symbol . All
safety regulations and/or symbols must be absolutely adhered to, so that
any dangerous situation is avoided .
1 .2

Warranty and liability claims

In order to safeguard warranty and liability claims, the following information must
be observed:
− Implementation according to the installation and operating instructions for the
unit.
− The use of accessories, which are not approved, recommended or offered by
Helios, is not permissible. Any damages are excluded from the warranty.
If these instructions are not observed, all warranty claims and accommodation
treatment are excluded. This also applies to any liability claims extended to the
manufacturer.
1 .3

Regulations - Guidelines

lf the product is installed correctly and used to its intended purpose, the unit
conforms to all applicable regulations and CE guidelines.
1 .4

Receipt

Please check delivery immediately on receipt for accuracy and damage. lf
damaged, please notify the carrier immediately. In case of delayed notification,
any possible claim may be void.
1 .5

Storage

The unit must be stored in dry and dust-free protected rooms.
When storing for a prolonged time, the following steps are to be taken to avoid
damaging influences: Protection by dry, air-dustproof packing (plastic bags with
drying agent and moisture indicators). The storage place must be waterpro-
of, vibration-free and free of temperature variations. Damages due to improper
transportation, storage or putting into ope-ration are not liable for warranty.
1 .6

Intended use

The controller is designed for controlling an AIR1 ventilation unit. It is not a rea-
dy-to-use product and it can only be used once the ventilation system has been
properly installed and connected.
Any use other than the intended use is not permitted!
1
EN