Inserting Batteries - LaserLiner CondenseSpot Pro Manual

n m
a
b
c
a
Condensation warning
b Bar graph, condensation moisture indicator
c Relative humidity measured value
1

Inserting batteries

Open the battery compartment and insert
batteries according to the symbols. Be sure
to pay attention to polarity.
3
Infrared temperature measurement / continuous measurement / Hold
1.
12
EN
l k j i h
g
f
MAX
e
MIN
d
2.
d Measured value in selected mode (MIN / dew
point temperature) / emissivity factor display
e Measure value in selected mode
(MAX / ambient temperature)
f Measured value, infrared temperature
g Measurement °C
h Battery charge
i Laser beam switched on,
temperature measurement (infrared)
j Hold function
k Thermal bridge warning
l Bluetooth * function active
®
m Alarm function deactivated
n Alarm function active
2
ON / OFF
The device can also be switched on with the alarm
function button (3). No measurement is triggered
and the last measured values are displayed.
Auto switch-off after 30 seconds.
Make sure that the humidity/ambient
!
temperature sensor (4) is folded in
during transport
Display of infrared temperature
(in all measuring modes)
Press button 8 for infrared
temperature measurement.
1.
ON
2.
1 sec