Advertisement
Components, parts and materials containing
radioactive substances
2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Description
Star Head Screw Driver
Cross Head Screw Driver
Plastic Nipper
Nut Driver
Electric Iron
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
1.
Remove the middle bezel and left panel.
2.
Disconnect the battery connector, and press on/off button to discharge the rest electricity.
3.
Loosen the screws fixing the battery door, remove the battery door, and pull out the battery.
4.
Loosen the screws fixing the top cover, and remove the top cover.
5.
Disconnect the LCD cable and front FAN cable connecting to control PCBA, loosen the screws fixing the right panel
ASSY, and remove the right panel ASSY.
6.
Loosen the screws fixing the front FAN, and remove the front FAN.
7.
Disconnect the cables connecting to Slot box, AVR, rear FANs, I/O PCBA, and rear panel ASSY, and disassemble the
cable clip sticking on the mainframe, and loosen the screws fixing the main PCBA, then remove the main PCBA .
8.
Loosen the screws fixing the rear panel ASSY, disconnect the cables connecting to the I/O PCBA, loosen the nut
fixing ground cable to the mainframe, and then remove the rear panel ASSY.
9. Cut off the cable tie, disconnect the cables connecting to I/O PCBA, loosen the nuts fixing the AVR, and then remove
the AVR.
10. Remove the RPO connector, loosen the screws fixing Slot box, COM PCBA, rear FANs, and remove Slot box, COM
PCBA, and rear FANs.Loosen the screws fixing I/O PCBA, and then remove the I/O PCBA.
11. Loosen the screws fixing I/O PCBA, and then remove the I/O PCBA.
12. Disassemble right panel ASSY into separate parts.
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below to identify the items
contained in the product that require selective treatment (with descriptions and arrows identifying locations).
1. Remove the middle bezel and left panel.
2. Disconnect the battery connector, and press on/off button to discharge the rest electricity.
EL-MF877-00
Template Revision B
PSG instructions for this template are available at
EL-MF877-01
Tool Size (if
applicable)
M3
M3,M4
Normal
M4
Normal
Page 2
Advertisement
