Jeep KJ Liberty 2005 Service Manual page 32

BRAKES (25E)
PCI BUS COMMUNICATION —
TEST
8 Turn the ignition off.
Disconnect the ABM harness connector.
Measure the resistance of the PCI Bus circuit between the ABM harness connector
and the Data Link connector.
Is the resistance over 5.0 ohms?
Yes → Repair the PCI Bus circuit for an open.
→ Replace the Anti-Lock Brake Module in accordance with the
No
9 Turn the ignition off.
Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or
partially broken wires.
Visually inspect the related wire harness connectors. Look for broken, bent, pushed
out, or corroded terminals.
Refer to any Hotline letters or Technical Service Bulletins that may apply.
Were any problems found?
Yes → Repair as necessary.
→ Test Complete.
No
Continued
ACTION
Perform ABS VERIFICATION TEST - VER 1.
Service Information.
Perform ABS VERIFICATION TEST - VER 1.
Perform ABS VERIFICATION TEST - VER 1.
30
APPLICABILITY
All
All