Introduction; Firmware Versions - Mircom TX3-ER-8 Installation Manual

1

Introduction

This manual provides information about the installation and operation of the
TX3 Elevator Restriction System, and must be read in its entirety before
beginning any installation work.
Installation must be performed by a qualified technician and must adhere to the
standards and special notices set by the local regulatory bodies.
Note:
Warning: The Telephone Access System assembly must be grounded by a
This manual explains
•
1.1

Firmware Versions

Note:
TX3 panels run either version 2 firmware or version 3 firmware, depending on
their hardware.
•
•
•
If you have TX3-ER-8-B (ERU 2.0), see LT-995 TX3 System Configuration and
Administration Manual for firmware compatibility.
Elevator Restriction System Installation and Operation Manual
Mircom periodically updates panel firmware and Configurator
Software to add features and correct any minor inconsistencies. For
information about the latest firmware or software visit the Mircom
website at www.mircom.com.
qualified electrician. An improperly grounded unit can result in
equipment malfunction and electrical shock.
Elevator Restriction Unit Installation and Operation
For instructions on upgrading firmware see LT-995 TX3 System
Configuration and Administration Manual.
If your panels run version 2 firmware, you must upgrade to version 2.4.x
or higher in order to use floor groups.
If your panels run version 3 firmware, you must upgrade to version 3.4.x
or higher in order to use floor groups.
If you do not upgrade your panels to version 2.4.x or 3.4.x, you can still use
elevator restriction but you cannot use floor groups.
5