Advertisement
Total 13588979 bytes data downloaded.
Verifying the integrity of the firmware image.
Total 65536kB unzipped.
Save as Default firmware/Backup firmware/Run image without saving:[D/B/R]?
................................................................
Reading boot image 3954827 bytes.
Initializing firewall...
System is started.
Opencard Mode Selection Menu:
[1] Pre-Format
[2] F1-Format
[3] GetInfo
Enter selection [1, 2, or 3]:
Platform: FG80C
F1 format succeeded.
-------------------- Device Information --------------------
Unit: sector
SDK version=v04.00.01
Date=2013.01.09
SN=0700319140FFFF00
VID=13FE
PID=3100
Inquiry Version=1610 TSB-130313-1
Technical Service Bulletin
Inquiry Manufacturer=FORTINET
F/W Version=07.16.10
CDROMSize=0
SecureSize=0
Normal HiddenSize=0
IsExisted PWS Private=0
iController_ID=2233
--------------------------------------------------------
total capacity:14336000 sectors,
All done.
Congratulations! Opencard process succeeded. The device is ready to use now.
Opencard Mode Selection Menu:
[1] Pre-Format
[2] F1-Format
[3] GetInfo
Enter selection [1, 2, or 3]:
5) Load desired FortiOS image (4.0MR3 patch 12 in this example)
a) After the F1 format completes,power OFF the unit, wait for five (5) seconds and power ON again.
b) During boot-up sequence press any key to display configuration menu.
c) Using the TFTP upload procedure in step 3) load FortiOS 4.0MR3 patch 12 image to the FortiGate
flash.
If all the above steps have been completed without error the FortiGate FG80C has been successfully
re-formated to prevent the potential boot failure issue from occurring. For further assistance please
contact your local Fortinet technical support center.
2
Time=17:00
Manufacture Name=FORTINET
Product Name=80C_G2_FWV071610
Inquiry Product Name=80C_G2_FWV071610
Fortinet
8
FirmwareType=0xFF01
PublicSize=14336000
IsExisted Firmware code=1
IsLogin Private=0
iMode=3
7000 MB
R
Advertisement
