Advertisement
System is started.
Opencard Mode Selection Menu:
[1] Pre-Format
[2] F1-Format
[3] GetInfo
Enter selection [1, 2, or 3]:
ISP started, please wait...
Preformat succeeded!
4) Load and format F1 image
Power OFF the unit, wait for five (5) seconds and power ON again, reload the format image as in step
3 and choose "R" to run the image for next step F1-format as detailed below.
a) The system will start and open card mode selection menu will appear:
Opencard Mode Selection Menu:
[1] Pre-Format
[2] F1-Format
[3] GetInfo
b) Enter selection 2 for F1-format
c) Upon completion "F1 format succeeded" will be displayed
Below is a sample console output for the F1 format image loading when following the above steps:
FortiGate-80C (16:50-09.27.2011)
Ver:04000009
Serial number: FG80C3910000000
Technical Service Bulletin
RAM activation
Total RAM: 1024MB
Enabling cache...Done.
Scanning PCI bus...Done.
Allocating PCI resources...Done.
Enabling PCI resources...Done.
Zeroing IRQ settings...Done.
Verifying PIRQ tables...Done.
Disabling local APIC...Done.
Boot up, boot device capacity: 7000MB.
Press any key to display configuration menu...
..
[G]:
Get firmware image from TFTP server.
[F]:
Format boot device.
[B]:
Boot with backup firmware and set as default.
[I]:
Configuration and information.
[Q]:
Quit menu and continue to boot with default firmware.
[H]:
Display this list of options.
Enter Selection [G]:
Enter G,F,B,I,Q,or H:
Please connect TFTP server to Ethernet port "1".
Enter TFTP server address [192.168.1.168]:
Enter local address [192.168.1.188]:
Enter firmware image file name [image.out]:
MAC:00090F4660A2############
1
G
FGT_80C-FORMAT.3.0.0.1001.out
Advertisement
