Toshiba APLEX4 Series Original Instruction page 16

Service Manual
CN4 connector (bottom right). I/O signals (optional).
Pin Name Description
1 OUT1
Pin1 and Pin2 are a free-voltage contact when the OUT1 is ON
2 OUT1
3 OUT2
Pin3 and Pin4 are a free-voltage contact when the OUT2 is ON
4 OUT2
5 V24 Power 24V (external)
6 GND 0V ground (external)
Notes:

The connector is not supplied with the APLEX, only with the accessory.

There is an optional kit to use these signals. This kit includes the connector, in/out board,
harness and screws and instructions.

OUT1 & OUT2 functionality can be configured on APLEX configuration menu.

IN signal can be used to clear any APLEX error. This avoids the need to push the TEST
button when any error appears.
Output circuit: OUT1 & OUT2, normally OPEN
OUT1
OUT2
Input circuit:
IN
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5 (+24V)
Pin 6 (GND)
16