Extreme Networks ExtremeSwitching SLX 9150 Hardware Installation Manual page 61

Activating and Verifying the Switch
a. 10/1000BASE-T Gbps SFP28 Ethernet ports
b. 1000Gbps QSFP28 Ethernet ports
c. USB port
d. Console port RJ45
e. Management Set sliding button*
Figure 31: Port-side view of the SLX 9150-48XT Switch
3. Access the device using a terminal emulator application (such as HyperTerminal in a Windows
environment or Tip in a LINUX environment).
4. Disable any serial communication programs running on the workstation (such as synchronization
programs).
5. Open a terminal emulator application (such as HyperTerminal on a PC, or TERM, Tip, or Kermit in a
LINUX environment), and configure the application as follows:
•
In a Windows environment:
Parameter
Bits per second
Data bits
Parity
Stop bits
Flow control
•
In a LINUX environment, enter the following string at the prompt:
tip /dev/ttyb -115200
If ttyb is already in use, use ttya instead and enter the following string at the prompt:
tip /dev/ttya -115200
Note
The console or serial port is intended primarily for the initial setting of the IP address.
Note
Flow control is not supported on the serial consoles when attached to remote terminal
servers and must be disabled to ensure proper operation.
ExtremeSwitching SLX 9150 Hardware Installation Guide
Establishing a serial connection
Value
115200
8
None
1
None
61