Table of Contents
Advertisement
DISASSEMBLY
INSTRUCTIONS
1. Turn the Compact Juice Extractor OFF and
then unplug it from power outlet.
2. Remove the food pusher from cover.
3. Move the safety bar to the unlock position.
It is unlocked if it is at rest at the back of the
motor base.
4. Lift and remove cover from filter housing.
5. Carefully remove mesh filter basket/blade
from the filter housing by pulling up on the
sides of the rim. Be careful not to touch
the blades in the bottom of the basket.
6. Make sure the flow spout is in the closed
position. Remove the juice jug.
7. Remove the pulp container from the rear of
the motor base and empty.
OPERATING INSTRUCTIONS
1.
Make sure your Compact Juice Extractor is
properly assembled. (See Assembly
Instructions, page 6.)
2.
Plug the power cord into a 220-240V
electrical outlet.
3.
Make sure that the spout is in the open
position. Never juice with the spout in
the closed position.
4.
Wash all selected fruits or vegetables.
5.
While many fruits and vegetables will not
need cutting, any item with a diameter
larger than 7cm will need to be cut.
6.
Press the on/off button when ready to
begin. The blue LED light will illuminate.
7.
Lift the food pusher out of the feed tube
and drop your food into the opening. Push
through by inserting the food pusher and
pressing firmly.
8.
The juice will flow into the juice jug and the
pulp will accumulate in the pulp container.
9.
When finished juicing, press the On/Off
button to stop the motor.
10.
Before removing the juice jug from under
the spout, slide the spout to the closed
position. This will prevent juice from
dripping on the counter.
CLEANING AND
MAINTENANCE
Do not immerse the motor housing in water or
spray it with water. Clean only by wiping with a
damp sponge, cloth or paper towel. Use any liquid
dishwashing detergent, but do not use any
products containing ammonia or scouring powders,
as these products will dull, scratch or mar the finish.
For easy cleanup, use cleaning brush to
remove excess pulp from the filter/Juice
Strainer and the lid after each use. Vegetables
and fruits will harden if left to dry on the unit
parts, making it harder to clean.
• Unplug juicer and carefully take it apart,
following Disassembly Instructions on this page.
• WARNING: Be careful when handling the
mesh filter basket/blade, as blades are very
sharp.
• Rinse all removable parts with cold water.
• Wash the pulp container, juice jug, pusher, lid
and mesh filter basket/blade in hot, sudsy
water, or on top rack of dishwasher. Do not use
a metal brush or pad.
• NOTE: For best juicing results, the mesh filter
basket/blade must always be thoroughly
cleaned after each use.
• Towel dry all parts.
• Any other servicing should be performed by
an authorised service representative.
7
Advertisement
Table of Contents
