Paslode F2N1-200 Operating Manual page 10

F
ASTENERS ARE NOT SET COMPLETELY
• First, verify air supply
• Clean tool and lubricate tool; particularly the head assembly
• Increase air pressure when working with harder woods; do not exceed 110 psi (7.6
bar)
• Check the driving blade for broken end
• Check piston wear-ring P-622A; replace if piston is sliding to easily
• Check seal bushing P-525B
• Check the adjustment of the base and ensure the tool is well seated on the floor
while ejecting
T
OOL DOES NOT ACTIVATE
• Check the air supply
• Inspect the head assembly and check all seals; reassemble carefully
D
RIVING BLADE DOES NOT RETURN
• Check for jammed fastener or obstruction
• Check gate/foot and end of feeder channel for damages or burrs.
• Check the driving blade
• Inspect the head assembly and check all seals; clean & lubricate.
• Check band-valve P-618A.
• Check that the bumper P-525A and seal bushing P-525B are in place.
BROKEN OR WORN DRIVING BLADE
Replace the driving blade. Failure to follow the instructions carefully will result in
repeated breakage of the driving blade.
P
OOR FEED OR TOOL JAMMING
• Make sure the feeder clip engages behind the fasteners
• Check the gate/foot assembly for damages or wear
• Check the front end of the feeder channel for burrs or damages