Table of Contents
Advertisement
Getting Started
INSTALLATION CHECKLIST
Electrical Power
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Plug refrigerator into a earthed socket.
■
Doors
If doors need to be removed during installation, see the
■
"Remove and Replace Refrigerator Doors" and "Remove and
Replace Freezer Door Fronts" sections.
Doors seal completely.
■
Refrigerator is level. Adjust leveling feet so they are snug
■
against the floor.
Doors are even across the top. (Use door alignment feature if
■
necessary).
Final Checks
Remove all shipping material.
■
Set temperature controls to the recommended setting.
■
Save instructions and other literature.
■
In order to receive a more complete assistance, please
■
register your product on www.whirlpool.com.
Water Filter Installation
Locate the water filter compartment in the lower left-hand side
n
of the refrigerator compartment. Push on the right side of the
filter door to open.
Align the arrow on the water filter cap with the cutout notch in
n
the filter housing and insert filter.
Once the filter is inserted, turn the filter clockwise 90° (1/4
n
turn) until it locks into the housing.
Push water filter door closed to latch.
n
Flush 3 gallons (11.4 L) of water through the water system to
n
clear air from the water line and to keep the dispenser from
dripping and/or avoiding decreased dispenser flow.
Reset the filter counter via user interface. See the procedure
n
to reset the filter in the User Controls section.
INSTALLATION INSTRUCTIONS
NOTE: If the filter is not installed correctly, water may dispense at
a lower flow rate and there will be slower ice production. Improper
filter installation may also cause the water filter housing to leak.
Unpack the Refrigerator
WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
Refrigerator Delivery
A minimum door opening of 838 mm (33") is required. If door
opening is 914 mm (36") or less, then removal of doors, drawer
and hinges is required.
Cart the refrigerator from the side for all door openings.
When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the refrigerator for
cleaning or service, be sure to cover the floor with
cardboard or hardboard to avoid floor damage. Always pull
the refrigerator straight out when moving it. Do not wiggle or
"walk" the refrigerator when trying to move it, as floor
damage could occur.
Remove the Packaging
Remove tape and glue residues from surfaces before
■
turning on the refrigerator. Rub a small amount of liquid dish
detergent over the adhesive with your fingers. Wipe with warm
water and dry.
Do not use sharp instruments, rubbing alcohol, flammable
■
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your refrigerator.
Dispose of/recycle all packaging materials.
■
Clean Before Using
After you remove all of the packaging materials, clean inside of
your refrigerator before using it. See cleaning instructions in the
"Refrigerator Care" section.
Important information to know about glass shelves
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
Tempered glass is designed to shatter into many small,
pebble-size pieces. This is normal. Glass shelves and covers
are heavy. Use both hands when removing them to avoid
dropping.
11
Advertisement
Table of Contents
Troubleshooting
