Refrigerator Use; Opening And Closing Doors - Whirlpool W11413618B Use And Care Manual

Opening and Closing Doors

There are two fresh food compartment doors. The doors can
be opened and closed either separately or together. There is a
vertically hinged seal on left refrigerator door.
When left-side door is opened, hinged seal automatically folds
■
inward so that it is out of the way.
When both doors are closed, the hinged seal automatically
■
forms a seal between two doors.
NOTE: When closing the door, the hinged seal should be in
correct position (be bent inside). Otherwise it will hit the right door
or the fixing shaft.
A
A. Hinged seal
The fresh food compartment door switch is located in top left and
right hinge cover.
For Freezer and Convertible Space, door switch is located in
■
the bottom mullion.
The door switch uses magnet to sense door opening/closing.
■
Ensure there are no magnet or electronic devices (Speaker,
■
Coolvox etc.) within 7.62 cm of the hinge cap.
®
NOTE: The light will not turn on if door opening is not detected.
A
A. Hinge cover

REFRIGERATOR USE

Shelf Height Adjustment
Shelf height can be adjusted by changing its location from bottom
support to upper support and vice versa.
Open right side door and left side door till 130º.
■
130°
The Ice Dispenser
IMPORTANT:
If the ice cubes are hollow or have an irregular shape, it could
n
be because of low water pressure. See the "Water Supply
Requirements" section.
Ice travels from the ice storage bin through the dispenser
n
chute to the dispenser. To turn off the ice maker, see the
"Ice Maker and Storage Bin" section.
The dispenser may continue to make noise and ice may
n
continue to dispense for several seconds after releasing
the dispenser button or paddle.
To Clean the Ice Dispenser Chute:
Humidity causes ice to naturally clump together. Ice particles can
build up until the ice dispenser chute becomes blocked.
If ice is not dispensed regularly, it may be necessary to empty the
ice storage bin and clean the ice delivery chute, the ice storage
bin, and the area beneath the storage bin every 2 weeks.
If necessary, remove the ice clogging the storage bin and
n
delivery chute using a plastic utensil.
Clean the ice delivery chute and the bottom of the ice storage
n
bin using a warm, damp cloth, and then dry thoroughly.
To Dispense Ice - Paddle Dispensing
1. Select the desired type of ice by pressing CUBED ICE or
CRUSHED ICE.
WARNING
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
2. Press a sturdy glass against the dispenser paddle. Hold the
glass close to the dispenser opening, so ice does not fall
outside of the glass.
IMPORTANT: You do not need to apply a lot of pressure to
the paddle to activate the ice dispenser. Pressing hard will not
make the ice dispense faster or in greater quantities.
130°
Cut Hazard
27