Regulation And Operation; Led And Buzzer - DeLonghi Fivy Vertical Instructions Manual

4. REGULATION AND OPERATION

The appliance is designed to heat
rooms.
GB
Some parts of this product can be-
come very hot and cause burns.
Particular attention has to be given
where children and vulnerable peo-
ple are present.
terials or pressure vessels (e.g. spray
from the appliance. Do not vaporise
any type of substance on the surface of
the appliance.
Never touch the appliance with wet or damp
hands or feet.
Do not wet the electronic control unit with water
pliance from the mains power supply and allow to
dry completely.
When the appliance is installed at high altitude,
the air will be hotter than the set temperature.
Possible traces of oil noted on the bottom of the
turn the appliance on may be left from the fabri-
cation process. Clean the part with proper precau-
tions at intervals of a couple of days. If the problem
reoccurs, follow the instructions in Chapter 7.
In cold conditions, the radiator may emit metallic
sounds when turned on. This is due to the expan-
sion of the materials.
4.1 OPERATION
The appliance is controlled by an infrared remote control
which allowes access to all functions.
In case the remote control is unavailable (due to batteries
out of charge or malfunctions), the radiator can be turned
on and off using the "Standby" key on the bottom of the ra-
diator. (Fig. 8, Chap. 4.6).
4.2 OPERATION WITH REMOTE CONTROL UNIT
The appliance is controlled by an infrared remote control
with LCD display.

4.2.1 LED AND BUZZER

The control LEDS allow you to immediately recognize the
active mode (Fig. 8).
Fig. 8
-
STANDBY key /
Infrared receiver
RIGHT LED
-
Green
Red
Blue
Yellow
White
Flashing green
Flashing red
Yellow and red alternating
Pulse green
LEFT LED
Red
Off
Blinking red (2
seconds)
Flashing red
The Command is equipped with a beeper that signals the
beeps (see Chap. 4.3).
16
LEDS
Standby
Pilot Wire
Comfort
Night/Eco
Chrono
Anti-Freeze
Overdrive (2h)
Malfunctioning
No power supply
The heating element is on.
The heating element is off.
Transmission of the signal from the
remote control.
An open window has been detected.