Opening The Cover - Master Spas axis Installation & User Manual

OPENING THE COVER

ATTENTION:
Be sure to remove any foreign objects such as small sticks,
branches, or other debris from the top of cover before rolling
it open. This prevents damage from occurring and debris from
getting into the swim spa when it is rolled closed again. Tears
or puncture damage caused to the cover by foreign objects
are not covered by the limited warranty.
Unlock and release all cover locks along the long sides of the
cover. Lift up the cover skirt to access the Rotating Lever
Latch, push against the 8' lever arm at the end of the cover
and turn Rotating Lever Latch to release lever arm of cover.
Repeat for opposite end.
Flip the vinyl cover skirting over on top of the cover at the
corners to prevent these points from catching and being
damaged when starting to roll cover open (Figure 11).
Standing at one end of the swim spa, start rolling cover until
it is out of reach (Figure 12). Then, move to the long side
of the swim spa. Grasp the rolled portion of the cover by
the grey insulating bag (Figure 13) and continue rolling cover
open until it is past the entry step area in the swim spa
(approximately 3' to 5').
From this point; it is easiest to get into the swim spa, standing
in the center, to continue rolling cover open. Push upward on
the bottom grey insulating bag of the cover (Figure 14) and roll
until the cover is fully removed from over the body of water
(Figure 15).
BE SURE NO PERSON, CHILD OR ANIMAL IS POSITIONED
AT THE END OF THE SWIM SPA WHERE THE COVER WILL
BE LOCATED WHEN OPEN AND SWIM SPA IS IN USE. THE
ROLLED COVER IS HEAVY. SERIOUS OR FATAL INJURY
COULD OCCUR IF COVER ROLLS OR FALLS OFF THE END
OF THE SWIM SPA.
10
FIGURE 14